Module, Active Damping Control: Installation: Installation

Fig 1: ADCM & Three Mounting Screws

Courtesy of CHRYSLER GROUP, LLC

1. Slide the Active Damping Control Module (ADCM) (1) into position making sure the latches secure the ADCM.
2. Install the retaining screws (2) and tighten to 9 N.m (80 in. lbs.).
3. Connect the wire harness connectors to the ADCM (1).
4. Position the carpet back in the original location and install the fasteners.
5. Connect the negative battery cable. Refer to CABLES, BATTERY, INSTALLATION .
6. Perform the ADCM Verification Test.