Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- PERFORM TCM REPLACEMENT PROCEDURE NOTE:
Controller is programmed with generic software and will not allow the correct vehicle Powertrain management.
- With the scan tool, perform the TCM replacement procedure.
Were you able to update the controller successfully?
Yes
- Test Complete.
- Refer to STANDARD PROCEDURE and perform NAG1 TRANSMISSION VERIFICATION TEST.
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM per the Service Information. Refer to MODULE, TRANSMISSION CONTROL, DESCRIPTION .
- Refer to STANDARD PROCEDURE and perform NAG1 TRANSMISSION VERIFICATION TEST.
- With the scan tool, perform the TCM replacement procedure.