Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Electronic Control Modules (Service Information) 1500) >> Module, Ignition Node >> Removal >> Removal

Module, Ignition Node: Removal: Removal

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the instrument panel end cap (driver side).
  3. Remove the kneeblocker/lower steering column opening trim.
  4. Remove the chin bezel located above the floor console. One fastener and snaps to console. Refer to CONSOLE, FLOOR, REMOVAL .
  5. Remove the four (4) screws that retain the ignition node.
  6. Disconnect the harness connector and remove the ignition node.
scientia non olet · About Mike's Workshop Manuals