Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Electronic Control Modules (Service Information) 1500) >> Module, A/C And Heater >> Installation >> Installation

Module, A/C And Heater: Installation: Installation

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the wire harness connector to the A/C heater module.
  2. Position the A/C heater module to the instrument panel, through the glove box opening and engage the module retaining screws to the slots on instrument panel.
    Fig 1: Two Screws & A/C Heater Module
    GC0154539Courtesy of CHRYSLER GROUP, LLC
  3. Tighten the two screws (1) that secure the A/C heater module (2) to the instrument panel to 2 N.m (17 in. lbs.).
  4. Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
  5. Install the right side instrument panel end cap.
  6. Connect the negative battery cable.
  7. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About Mike's Workshop Manuals