Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Memory Seat Module (MSMD) - Electrical Diagnostics) >> Standard Procedure >> Power Seat System Verification Test >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM POWER SEAT SYSTEM VERIFICATION TEST 
    1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
    2. Make sure that all accessories are turned off.
    3. Make sure that the battery is fully charged.
    4. Turn the ignition on.
    5. If either the Memory Seat Module (MSM) or the Driver Horizontal Seat Adjuster Motor/Seat Track was replaced, then the MSM Standard Routine must be performed using a scan tool.
    6. Using a scan tool, record and erase Diagnostic Trouble Codes (DTC's) from all modules.
    7. Operate the driver seat in all positions.
    8. Using the Memory Switch on the driver's door, program the driver's seat number 1 Button to a desired position and driver's seat number 2 Button to a different position.
    9. Verify both Memory positions can be recalled with the Remote Keyless Entry (RKE) transmitter and the Memory Switch on the driver's door.
    10. Turn the ignition off, wait 10 seconds, then turn the ignition on.
    11. Using a scan tool, select ECU View.
    12. Check for DTC's in the modules.

      Are DTC's present in any of the modules or is the original condition still present?

      Yes 

      • The Repair Is Not Complete. Refer To The Appropriate Diagnostic Information For The DTC Or Symptom That Is Still Present.

      No 

      • The repair is complete.
scientia non olet · About Mike's Workshop Manuals