Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, EDG >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Ignition Control (Service Information)) >> Spark Plug >> Removal >> 2.7L

Spark Plug: Removal: 2.7L

WARNING: This page is about a different car, the 2010 Dodge Avenger and 2010 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Electrical Connectors And Mounting Bolts At Ignition Coil
GC0121029Courtesy of CHRYSLER LLC
NOTE: Always remove the ignition coil assembly by turning the assembly 1/2 turn and pulling straight back in a steady motion.
  1. Disconnect the negative battery cable.
  2. Remove the upper intake manifold. Refer to REMOVAL .
  3. Disconnect electrical connector (1) from ignition coil.
  4. Remove mounting bolt (2) from ignition coil.
    CAUTION: Prior to removing the ignition coils, spray compressed air around the coils and spark plugs. If dirt and debris enter the engine, this may cause internal engine damage.
  5. Remove the ignition coils.
  6. Remove the spark plugs.
scientia non olet · About Mike's Workshop Manuals