Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Charging System (Service Information)) >> Generator >> Installation >> 2.7L

Section 60 (Charging System (Service Information)): Generator: Installation: 2.7L

WARNING: This page is about a different car, the 2010 Dodge Avenger and 2010 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: GENERATOR
GC0120978Courtesy of CHRYSLER LLC
  1. Install the generator.
  2. Install the 2 upper bolts but do not tighten.
    Fig 2: GENERATOR BATTERY CABLE
    GC0120977Courtesy of CHRYSLER LLC
  3. Connect the B+ terminal and field connectors.
  4. Install the lower bolt and tighten to 27 N.m (20 ft. lbs.).
  5. Install the accessory drive belt back on the generator.
  6. Tighten the 2 upper mounting bolts to 27 N.m (20 ft. lbs.).
  7. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals