Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2009 >> 300 Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (Electronic Control Modules (Service Information)) >> MODULE, Door >> Installation >> Installation

MODULE, Door: Installation: Installation

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Control Module To Inner Door Panel
GC0095225Courtesy of CHRYSLER LLC
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. Refer to Electrical/Battery System - Standard Procedure .
  1. Position the door control module (3) to the inner door panel (1).
  2. Press the two plastic push-in fasteners firmly and evenly into the mounting holes of the inner door panel.
  3. Reconnect the door wire harness connections to the door control module connector receptacles.
  4. Reinstall the trim panel onto the inside of the front door. Refer to Body/Door - Front/PANEL, Door Trim - Installation .
  5. Reconnect the battery negative cable.
scientia non olet · About Mike's Workshop Manuals