Switch - Ignition

Fig 1: Locating Ignition Switch

Courtesy of CHRYSLER LLC

Disconnect the negative battery cable.
Ignition switch location.

Fig 2: Identifying Center Stack Bezel
Courtesy of CHRYSLER LLC
Remove radio bezel. Refer to REMOVAL .

Fig 3: Identifying Switch Cover Bezel
Courtesy of CHRYSLER LLC
Remove instrument cluster bezel. Refer to REMOVAL .
Remove the knee bolster. Refer to REMOVAL .

Fig 4: Identifying Cluster Connectors
Courtesy of CHRYSLER LLC
Disconnect two electrical connectors from the back of instrument cluster.

Fig 5: Relocating Cluster
Courtesy of CHRYSLER LLC
Relocate instrument cluster to the left.

Fig 6: Removing/Installing Switch Mounting Screws
Courtesy of CHRYSLER LLC
Remove the two front mounting screws for ignition switch.

Fig 7: Identifying Switch Rear Mounting Screw
Courtesy of CHRYSLER LLC
Remove one rear mounting screw and washer from ignition switch.

Fig 8: Identifying Switch Locking Tab
Courtesy of CHRYSLER LLC
Use a thin screw driver and unclip ignition switch from mounting position. Push switch back to remove.

Fig 9: Identifying Module Electrical Connector
Courtesy of CHRYSLER LLC
Push switch back and down to opening from knee bolster area.

Fig 10: Identifying Interlock Cable
Courtesy of CHRYSLER LLC

1 - Ignition Switch Assembly

2 - Shift Interlock Cable
Disconnect shift interlock cable. Refer to REMOVAL .
Remove ignition switch assembly.