Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2008 >> Sebring Base, 2D Convertible, 2.4 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Power Liftgate System (Service Information)) >> Power Liftgate System - Service Information >> Module - Power Liftgate Control >> Removal >> Power Liftgate Control Module

Power Liftgate Control Module

WARNING: This page is about a different car, the 2008 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Liftgate Control Module
GC0049022Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the left quarter trim panel from the vehicle, refer to REMOVAL .
  3. Disconnect the wire harness connectors (5) from the power liftgate control module (3).
  4. Remove the power liftgate control module (3) retaining screw (4).
  5. Tilt the top of the module (3) away from the quarter panel (1) and lift upward to disengage the mounting tab from the locating slot.
  6. Remove the power liftgate control module (3) from the vehicle.
scientia non olet · About Mike's Workshop Manuals