Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2008 >> Sebring Base, 2D Convertible, 2.4 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Exhaust System) >> Shields-Heat >> Installation >> Heat Shield-Installation-Toe Board

Heat Shield-Installation-Toe Board

WARNING: This page is about a different car, the 2008 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Toe Board Heat Shield
GC0049828Courtesy of CHRYSLER LLC
1 - NUTS
2 - TOE BOARD HEAT SHIELD
  1. Position toe board heat shield to underbody.
  2. Install heat shield nuts and tighten to 2.6 N.m (23 in. lbs.).
  3. Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.
  4. Lower vehicle.
scientia non olet · About Mike's Workshop Manuals