Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2008 >> Sebring Base, 2D Convertible, 2.4 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Ignition Control (Service Information)) >> PLUG, Glow >> Installation >> Installation

PLUG, Glow: Installation: Installation

WARNING: This page is about a different car, the 2009 Dodge Avenger and 2009 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Glow Plugs
GC0098506Courtesy of CHRYSLER LLC
  1. Clean glow plug bay and install glow plug.
  2. Tighten glow plugs to 10 N.m (89 lbs. in.).
  3. Connect glow plug electrical connector.
  4. Install cylinder head cover.
  5. Install engine cover.
  6. Connect negative battery cable.
scientia non olet · About Mike's Workshop Manuals