Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2008 >> Sebring Base, 2D Convertible, 2.4 K >> Repair and Diagnosis >> Electrical >> Starter >> Starting System (Service Information) >> Starting - Service Information >> Remote Start Antenna Module >> Removal >> Module - Remote Start Antenna - LHD

Module - Remote Start Antenna - LHD

Fig 1: REMOTE START ANTENNA CONNECTOR
GC0072300Courtesy of CHRYSLER LLC
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this may result in serious or fatal injury.

The remote start antenna is located driver's side front of dash.

  1. Disconnect and isolate the battery negative cable.
  2. Remove radio. Refer to REMOVAL .
  3. Remove instrument cluster. Refer to REMOVAL .
  4. Remove the instrument panel top pad. Refer to REMOVAL .
    NOTE: During removal of the remote start antenna note the routing location of the coaxial cable.
  5. Disconnect remote start antenna coaxial cable connector (1) from SKREEM module (3).
  6. Remove the mounting clip (2).
    Fig 2: LHD REMOTE START ANTENNA
    GC0072301Courtesy of CHRYSLER LLC
  7. Remove the mounting clip at the steering column reinforcement bracket.
  8. Remove screws (1) and remove remote start antenna (2) from instrument panel assembly.
scientia non olet · About Mike's Workshop Manuals