Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2007 >> Town & Country Base >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Diagnostic Procedures - Introduction & Diagnostic Code Index >> System Description And Functional Operation >> Overhead Console >> Tire Pressure Monitoring System (TPMS) >> Training The SKREEM

Training The SKREEM

If a Sensor/Transmitter is replaced, the vehicle has to be parked for at least 15 minutes for the system to be ready to learn the new Sensor/Transmitter ID code. The vehicle then must be driven for a minimum of five minutes with a minimum continuous speed above 13 mph (20 km/h). The system will learn the new Sensor/Transmitter and clear the DTC's automatically. The Sensor/Transmitters are programmed at the assembly plant in this clockwise orientation:

Sensor/Transmitter 1 = Left Front

Sensor/Transmitter 2 = Right Front

Sensor/Transmitter 3 = Right Rear

Sensor/Transmitter 4 = Left Rear

NOTE:
  1. If one or all Sensor/Transmitters cannot be trained, check for and avoid RF interference.
  2. If one Sensor/Transmitter still cannot be trained, replace it and retry.
  3. If all Sensor/Transmitters still fail to train, replace the SKREEM.
scientia non olet · About Mike's Workshop Manuals