Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2007 >> Sebring Base, 2.7 R, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Electronic Control Modules (Service Information)) >> MODULE, Door >> Installation >> Installation

MODULE, Door: Installation: Installation

WARNING: This page is about a different car, the 2009 Dodge Avenger and 2009 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electrical Connectors
GC0104140Courtesy of CHRYSLER LLC
  1. Install the module and mounting fasteners.
  2. If applicable, first connect the black 12-way electrical connector (3), then connect the brown 20-way electrical connector (2). Then connect the black 10-way electrical connector to the module (1).
  3. Install the door trim panel. Refer to Body/Door - Front/PANEL, Door Trim - Installation .
  4. Connect the battery negative cable.
scientia non olet · About Mike's Workshop Manuals