Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2007 >> Sebring Base, 2.4 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Anti-Lock Brake System (Service Information)) >> Electrical >> SWITCH, Electronic Stability Program (ESP) >> Installation >> Installation

SWITCH, Electronic Stability Program (ESP): Installation: Installation

WARNING: This page is about a different car, the 2009 Dodge Avenger and 2009 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The ESP Off switch is serviced as part of the accessory switch bank.
NOTE: There are different instrument panel accessory switch banks available based on the option content of the vehicle. Ensure the accessory switch bank being installed matches the vehicle options.
  1. Position the accessory switch bank onto the back of the instrument panel center bezel.
  2. Install the screws that secure the accessory switch bank to the center bezel. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Install the center bezel onto the instrument panel. Refer to Body/Instrument Panel/BEZEL, Instrument Panel - Installation .
  4. Reconnect the negative battery cable.
  5. Perform the ABS Verification Test and make sure the ESP Off switch operates properly. See Brakes - Standard Procedure 
  6. Verify proper operation of all components controlled by the switch bank.
scientia non olet · About Mike's Workshop Manuals