Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2007 >> Pacifica Limited, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (EGR Function Testing - CHRYSLER Trucks) >> EGR Function Testing - CHRYSLER Trucks >> Test 1 >> Ported EGR System

Ported EGR System

WARNING: This page is about a different variant/trim than selected.
  1. Check vacuum lines for correct routing. Warm engine to normal operating temperature. Some models with EGR delay timers must operate at least 1-2 minutes for EGR to function.
  2. While watching EGR pintle, abruptly accelerate engine to 2000-3000 RPM. EGR pintle should open at least 1/8". If EGR pintle does not move, check for cracked, leaking, disconnected or plugged vacuum hose. Verify correct vacuum hose routing.
  3. Connect a hand-held vacuum pump to EGR valve. Idle engine and gradually apply a minimum of 10 in. Hg. EGR valve stem should move and engine speed should drop at least 150 RPM.
scientia non olet · About Mike's Workshop Manuals