Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2007 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (3.5L Engine (Service Information)) >> Engine Block >> Damper-Vibration >> Installation >> Vibration Damper

Vibration Damper

WARNING: This page is about a different car, the 2007 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Filter/Cooler Housing, Idler Pulley, Vibration Damper Bolt And Crankshaft Damper
GC0066246Courtesy of CHRYSLER LLC
  1. Raise vehicle on hoist.
  2. Install the vibration damper bolt. Tighten the bolt to 200 Nm (148 ft. lbs.).
    Fig 2: Accessory Drive Belt Bolt
    GC0066190Courtesy of CHRYSLER LLC
  3. Install the accessory drive belt. Refer to INSTALLATION .
    Fig 3: Crankshaft Locking Tool
    GC0066245Courtesy of CHRYSLER LLC
  4. Remove the crankshaft locking tool.
    Fig 4: Remote Ground
    GC0066161Courtesy of CHRYSLER LLC
  5. Connect negative battery cable.
scientia non olet · About Mike's Workshop Manuals