Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2007 >> 300 Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints System (Service Information) >> Sensor - Seat Weight >> Removal >> Power Front Passenger Seat

Power Front Passenger Seat

Fig 1: Removing/Installing Front Passenger Seat
GC0013585Courtesy of CHRYSLER LLC
NOTE: If the vehicle is equipped with a power front passenger seat, to remove the adjuster from the riser it is necessary to have battery power to move the seat forward and rearward to access the mounting bolts.
  1. Remove front passenger seat mounting bolts. Refer to REMOVAL .
    Fig 2: Passenger Seat Manual Track
    GC0013581Courtesy of CHRYSLER LLC
  2. Remove the adjuster to riser mounting bolt (3). For additional information. Refer to REMOVAL .
  3. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.
    Fig 3: Seat Weight Sensor
    GC0016672Courtesy of CHRYSLER LLC
  4. Remove the two nuts (2) holding the seat weight sensor (4) to the seat riser.
  5. Disconnect the one electrical connector (1).
scientia non olet · About Mike's Workshop Manuals