Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2007 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Exhaust System) >> Motor-Boost Pressure Servo >> Installation >> Servomotor

Motor-Boost Pressure Servo: Installation: Servomotor

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Servomotor
GC0039548Courtesy of DAIMLERCHRYSLER CORP.
  1. Install actuator rod onto servomotor (4). See Fig 1.
  2. Install circlip (1). See Fig 1.
  3. Position servomotor and actuator rod onto turbocharger (5). See Fig 1.
  4. Install mounting bolts (3). See Fig 1. Tighten bolts to 8 N.m (70 lbs.in).
  5. Install circlip on the actuator rod at the turbocharger end (2). See Fig 1.
  6. Connect electrical connector (6). See Fig 1.
  7. Install the turbo heat shield.
  8. Connect negative battery cable.
  9. Install air cleaner housing.
  10. Connect negative battery cable.
scientia non olet · About Mike's Workshop Manuals