Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (HVAC Systems) >> Controls >> A/C Compressor Clutch >> Standard Procedure >> A/C Clutch Break-In

A/C Clutch Break-In

WARNING: This page is about a different car, the 2006 Dodge Viper. However, it is still accessible from the selected car via links, so may be relevant.

After a new A/C compressor clutch has been installed, cycle the compressor clutch approximately twenty times (five seconds on, then five seconds off). During this procedure, set the A/C-heater controls to the A/C Recirculation Mode, the blower motor in the highest speed position, and the engine speed at 1500 to 2000 RPM. This procedure (burnishing) will seat the opposing friction surfaces and provide a higher compressor clutch torque capability.

scientia non olet · About Mike's Workshop Manuals