Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> Engine Performance >> System >> Powertrain Diagnostic Procedures >> Diagnostic Information And Procedures >> Diagnostic Tests >> P0632-Odometer Not Programmed In Pcm >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC PROCEDURES - P0632-ODOMETER NOT PROGRAMMED IN PCM

TEST ACTION APPLICABILITY
1 Ignition on, engine not running.
With the DRBIII®, erase DTCs.
Using the DRBIII®, program the mileage into the PCM.
Start the engine.
Allow the engine to reach normal operating temperature.
With the DRBIII®, read DTCs.
Does the DTC reset?
Yes --> Go To 2
No --> The mileage has been successfully programmed into the PCM.
Test is complete.
Perform POWERTRAIN VERIFICATION TEST VER - 1 .		 All
2
NOTE: The ignition switch must be left in the off position for a minimum of 10 seconds.
Cycle the ignition switch to the off position and then back to run.Attempt to program the PCM with the applicable information.Start the vehicle and allow it to reach normal operating temperatures.With the DRBIII®, read DTCs.Does the DTC reset?Yes --> Replace and program the Powertrain Control Module in accordance with the Service Information.Perform POWERTRAIN VERIFICATION TEST VER - 1 .No --> The mileage has been successfully programmed into the PCM.Test is complete.Perform POWERTRAIN VERIFICATION TEST VER - 1 .		 All
scientia non olet · About Mike's Workshop Manuals