Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2006 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Mechanical Brake System - Base (Service Information)) >> Alb Controller >> Installation

Alb Controller: Installation

WARNING: This page is about a different car, the 2006 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ALB controller to the vehicle.
  2. Install the mounting bolts for the controller.
  3. Install the brake lines. Tighten the lines to 16 N.m (142 in. lbs.)
  4. Install the adjusting rod, nut and spring to the ALB controller.
  5. Lower the vehicle.
  6. Remove the brake pedal hold down rod.
  7. Fill and bleed the brake system (Refer to BRAKES - STANDARD PROCEDURE) .
  8. Raise the vehicle and adjust the ALB controller (Refer to BRAKES/HYDRAULIC/MECHANICAL/ALB CONTROLLER - ADJUSTMENTS) .
  9. Lower the vehicle and test drive.
scientia non olet · About Mike's Workshop Manuals