Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2006 >> 300 Base, 42RLE/VLP >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - DTCS P2008 To P2138 >> Diagnosis And Testing >> P2115-Accelerator Pedal Position Sensor 1 Minimum Stop Performance >> Diagnostic Test

Diagnostic Test

  1. 1)  IN PLANT TEST FAILURE 

    Ignition on, engine not running.

    NOTE: This DTC is set when the APP Sensors are learned in plant but do not reach the Minimum or Maximum voltage range.

    With a scan tool read DTCs.

    With the scan tool, erase DTCs.

    Start the engine.

    With the scan tool, read DTCs.

    NOTE: Diagnose any APPS out of Range and 5-Volt Supply DTCs before continuing.

    Is the DTC active at this time? 

    Yes 

    1. Go To  2).

    No 

    1. Refer to INTERMITTENT CONDITION .
    2. Perform POWERTRAIN VERIFICATION TEST .
  2. 2)  APPS RELEARN 

    With a scan tool select the ETC RELEARN function.

    Next, erase DTCs.

    Start the engine.

    Does the DTC return? 

    Yes 

    1. Replace the APPS Assembly per Service Information. After installation is complete, use a scan tool and select the ETC RELEARN function.
    2. Perform POWERTRAIN VERIFICATION TEST .

    No 

    1. Test Complete.
scientia non olet · About Mike's Workshop Manuals