Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2005 >> Sebring TSi >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Cruise Control Systems - Coupe) >> On-Vehicle Service >> Auto-Cruise Control System Component Check >> Stoplight Switch

Stoplight Switch

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the connector.
  2. Check for continuity between the terminals of the switch.
    TERMINAL CONNECTOR SPECIFIED CONDITION CHART

    MEASUREMENT CONDITIONS TERMINAL CONNECTOR OF TESTER SPECIFIED CONDITION
    When brake pedal is depressed. (for stoplight circuit) 1 - 2 Less than 2 ohms
    3 - 4 Open circuit
    When brake pedal is not depressed. (for auto-cruise control circuit) 1 - 2 Open circuit
    3 - 4 Less than 2 ohms
    Fig 1: Disconnecting Connector
    G04539463Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About Mike's Workshop Manuals