Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2005 >> Sebring TSi >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Cruise Control Systems - Coupe) >> On-Vehicle Service >> Auto-Cruise Control Switch Check >> Speed-reduction Setting

Speed-reduction Setting

WARNING: This page is about a different variant/trim than selected.
  1. Set to the desired speed.
  2. Push the auto-cruise control switch in the direction of arrow.
  3. Check to be sure that deceleration continues while the switch is pressed, and that after it is released the constant speed at the time when it was released becomes the driving speed.
    NOTE: When the vehicle speed reaches the low limit [approximately 40 km/h (25 mph)] during deceleration, the auto-cruise control will be cancelled.
    Fig 1: Identifying Auto-Cruise Control Switch Direction
    G04539461Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About Mike's Workshop Manuals