Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Body Control Modules) >> System Tests >> Exterior Lighting >> Park Lamp Output 2 Short To Battery

Park Lamp Output 2 Short To Battery

WARNING: This page is about a different car, the 2002 Dodge Grand Caravan, 2002 Dodge Caravan, 2002 Chrysler Voyager, and 2002 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Turn ignition on. Using scan tool, clear all Front Control Module (FCM) DTCs. Turn parking lights on. Recheck for DTCs. If PARK LAMP OUTPUT 2 SHORT TO VOLTAGE resets, go to next step. If PARK LAMP OUTPUT 2 SHORT TO VOLTAGE does not reset, conditions necessary to set this DTC are not present at this time. Check for intermittent poor connections or faulty circuits and repair as necessary.
  2. Remove park light relay from Intelligent Power Module (IPM) located in left front corner of engine compartment. See Figure. Install a known-good relay. Turn parking lights on. If parking lights do not operate properly, go to next step. If parking lights operate properly, replace relay.
  3. Remove park light relay and FCM from IPM. See FRONT CONTROL MODULE  under REMOVAL & INSTALLATION. Using DVOM, measure voltage between ground and park light relay cavity terminal No. 85. If voltage is greater than one volt, replace IPM. If voltage is one volt or less, replace FCM. See FRONT CONTROL MODULE  under REMOVAL & INSTALLATION.
scientia non olet · About Mike's Workshop Manuals