Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls - Tests W/Codes) >> Self-Diagnostic System >> On-Board Diagnostics >> Monitored Circuits

Monitored Circuits

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Dodge Grand Caravan, 2002 Dodge Caravan, 2002 Chrysler Voyager, 2002 Chrysler Town & Country, and 2001 Dodge Grand Caravan. However, it is still accessible from the selected car via links, so may be relevant.

The Powertrain Control Module (PCM) contains electronic circuit monitors that monitor fuel, vehicle emissions, engine and ignition system performance. Monitors use information from various sensor circuits for system monitoring. Monitors do not indicate a specific component failure, but do indicate an implied failure within a specified system, and that the problem must be diagnosed. If any monitor detects a problem affecting vehicle emissions, a Diagnostic Trouble Code (DTC) will be stored in PCM. The following monitors are used.

The PCM will erase DTC once Malfunction Indicator Light (MIL) is turned off. Once MIL is turned off, PCM must pass diagnostic test for most recent DTC for 40 warm-up cycles on normal operation, or 80 warm-up cycles on engine misfire monitor or fuel system monitor.

NOTE: A warm-up cycle is defined as engine is started, an increase of 40°F in engine coolant temperature exists after engine is started and engine coolant temperature increases to at least 160°F.