Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Air Conditioning Controls) >> A/C Heater Control >> Removal

A/C Heater Control: Removal

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the center bezel from the instrument panel (Refer to INSTRUMENT PANEL CENTER BEZEL ).
  3. Remove the screws that secure the A/C-heater control to the instrument panel (Figure).
scientia non olet · About Mike's Workshop Manuals