Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2004 >> Sebring Base, 2D Coupe, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Electronic Control Modules - Except Coupe) >> Controller Antilock Brake >> Removal

Controller Antilock Brake: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable.
  2. Raise vehicle.
  3. Pull up on the CAB connector lock and disconnect the 24-way electrical connector and the pump/ motor connector from the CAB.
  4. Remove the bolts securing the integrated control unit's (ICU's) mounting bracket to the lower radiator support.
  5. Carefully move the ICU toward the right side of the car. Move the ICU far enough to access the CAB mounting screws. Be careful not to bend the brake tubes connected to the ICU. 
  6. Remove the screws securing the CAB to the HCU half of the ICU. Remove the CAB.
scientia non olet · About Mike's Workshop Manuals