Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2003 >> Sebring LXi, 2D Coupe, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing - Coupe - 3.0L >> Idle Control Systems >> Idle Air Control Motor >> Operation Check

Operation Check

Remove IAC motor from throttle body. See IDLE AIR CONTROL MOTOR under MOTORS, RELAYS & SOLENOIDS in REMOVAL & INSTALLATION - SEBRING COUPE & STRATUS COUPE article. Manufacturer recommends connecting Test Connector (MB991709) to IAC motor during testing procedure. Connect battery voltage to IAC terminals No. 2 and 5. See Fig 1 . Connect ground to the following IAC terminals in the following order:

  1. Terminals No. 1 and 4.
  2. Terminals No. 3 and 4.
  3. Terminals No. 3 and 6.
  4. Terminals No. 1 and 6.
  5. Terminals No. 1 and 4.

Repeat steps in reverse sequence. If IAC motor vibrates while testing, IAC is okay. If IAC motor does not vibrate during testing, replace IAC motor.

Fig 1: Identifying IAC Motor Terminals
G95I31151Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals