Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2003 >> Sebring LXi, 2D Coupe, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures - Coupe >> Ignition Systems >> Optical Ignition System (3.0L) >> Ignition Coil

Ignition Coil

NOTE: Ignition coil is part of distributor assembly and must be replaced as a unit.
  1. Disconnect distributor connector. To measure primary coil resistance, connect DVOM between distributor connector terminals No. 1 and 2 (component side). See Figure . Resistance should be 0.56-0.68 ohm. If resistance is not as specified, replace distributor.
  2. Remove distributor cap. To measure secondary coil resistance, connect DVOM between distributor high voltage terminal inside distributor and connector terminal No. 1 (component side). Resistance should be 9.4-12.8 k/ohms. If resistance is not as specified, replace distributor.
scientia non olet · About Mike's Workshop Manuals