Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2003 >> Sebring LXi, 2D Coupe, Standard >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Simplifies Wiring System (SWS) >> SWS Diagnosis >> Input Signal Chart

Input Signal Chart

If the input signal check finds a defect, perform appropriate inspection procedure.

INPUT SIGNAL CHART

SYMPTOMS INSPECTION PROCEDURE
The ignition switch (ACC) signal is not sent to the ETACS-ECU. O-1 
The ignition switch (IG1) signal is not sent to the ETACS-ECU. O-2 
The key reminder switch signal is not sent to the ETACS-ECU. O-3 
The hazard warning light switch signal is not sent to the ETACS-ECU. O-4 
The fog light switch signal is not sent to the ETACS-ECU. O-5 
The washer fluid level switch signal is not sent to the ETACS-ECU. O-6 
The driver's seat belt switch signal is not sent to the ETACS-ECU. O-7 
The driver's or passenger's door switch signal is not sent to the ETACS-ECU. O-8 
The driver's or passenger's door lock key cylinder switch signal is not sent to the ETACS-ECU. O-9 
The driver's or passenger's door lock actuator switch signal is not sent to the ETACS-ECU. O-10 
The door lock switch (incorporated in power window main switch and power window sub switch) signal is not sent to the ETACS-ECU. O-11 
The trunk lid latch switch signal is not sent to the ETACS-ECU. O-12 
The speed sensor signal is not sent to the ETACS-ECU. O-13 
Column switch The taillight switch signal is not sent to the ETACS-ECU. O-14 
The headlight switch signal is not sent to the ETACS-ECU.
The passing light switch signal is not sent to the ETACS-ECU.
The dimmer switch signal is not sent to the ETACS-ECU.
The turn-signal light switch signal is not sent to the ETACS-ECU.
The windshield mist wiper switch signal is not sent to the ETACS-ECU. O-15 
The windshield intermittent wiper switch signal is not sent to the ETACS-ECU.
The windshield low-speed wiper switch signal is not sent to the ETACS-ECU.
The windshield high-speed wiper switch signal is not sent to the ETACS-ECU.
The windshield intermittent wiper intervals adjusting knob signal is not sent to the ETACS-ECU. O-16 
The windshield washer signal is not sent to the ETACS-ECU. O-15 
Transmitter The lock, unlock, trunk or panic switch signal is not sent to the ETACS-ECU. O-17 
Sunroof switch The open/tilt up or close/tilt down switch signal is not sent to the ETACS-ECU. O-18 
ETACS-ECU does not receive a interior light loaded signal. O-19 
Check the circuit (power supply line) from the battery to the ETACS-ECU. P-1