Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2002 >> Sebring LXi, 2D Coupe, Standard >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Coupe >> System Tests >> Input Signal Check >> Test No. 18: Remote Keyless Entry System Transmitter Signal Is Not Sent To ETACS ECU

Test No. 18: Remote Keyless Entry System Transmitter Signal Is Not Sent To ETACS ECU

  1. Attempt to program transmitter. See PROGRAMMING in REMOTE KEYLESS ENTRY SYSTEMS - SEBRING COUPE & STRATUS COUPE article. If transmitter cannot be programmed, go to next step. If transmitter can be programmed, recheck lock, unlock and panic switch input signals.
  2. Remove transmitter battery and measure voltage. If battery voltage is 2.5-3.2 volts, go to next step. If battery voltage is not 2.5-3.2 volts, replace battery. Recheck lock, unlock and panic switch input signals.
  3. Attempt to program a different transmitter. If a different transmitter cannot be programmed, replace ETACS ECU. Recheck lock, unlock and panic switch input signals. If a different transmitter can be programmed, recheck lock, unlock and panic switch input signals.
scientia non olet · About Mike's Workshop Manuals