Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2002 >> Prowler >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Wiper Module >> Installation

Wiper Module: Installation

  1. Position the module in the cowl.
  2. Install the three mounting screws. Tighten the motor assembly mounting screws to 1.7 to 2.26 N.m (15 to 20 in. lbs.) torque.
  3. Connect the wire harness connector.
  4. Install the two module braces.
  5. Install the cowl trim cover and connect the washer hoses.
  6. Install the hood hinge.
  7. Install the upper hood left side panel.
  8. Install the engine compartment hood.
  9. Install wiper arms.
  10. Connect the battery negative cable.
scientia non olet · About Mike's Workshop Manuals