Circuit Description

DTC P0841 will set if an error is detected in any pressure switch. Transaxle uses pressure switches to monitor fluid pressure in L-R, 2-4 and OD elements. Pressure switches are continuously monitored for correct state in each gear. Effects to transmission are 1st gear and torque converter lock-up (EMCC) will be inhibited. The vehicle will start off in 2nd gear and shift normally through the gears without allowing EMCC. If during the same ignition key start, the set condition is no longer valid, the transmission will return to normal operation (1st and EMCC available). Limp-in will not occur unless DTC P0841 is accompanied by DTC P0706. MIL will illuminate after 5 minutes of substituted operation.