Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2002 >> Neon LE, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Ignition Systems >> Knock Sensor >> Removal & Installation

Removal & Installation

  1. Knock sensor is located on side of cylinder block, in front of starter. Disconnect knock sensor harness connector. Using a crow foot socket, remove knock sensor.
  2. To install, reverse removal procedure. Tighten knock sensor to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About Mike's Workshop Manuals