Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Systems - Automatic >> Removal & Installation >> A/C Compressor >> Installation

A/C Compressor: Installation

NOTE: If a replacement compressor is being installed, be certain to check the refrigerant oil level. Use only refrigerant oil of the type recommended for the compressor in the vehicle. See SPECIFICATIONS  .
  1. Position the A/C compressor in the vehicle and install the attaching bolts. Remove the plug or cap from the opened refrigerant line fittings. Install the suction line and discharge line fittings to the manifold on the A/C compressor. Tighten the fasteners to specifications. See TORQUE SPECIFICATIONS  .
  2. Install the drive belts. Connect the A/C compressor clutch coil wire lead. Connect the negative battery cable remote terminal from the remote battery post.
  3. Evacuate and charge the refrigerant system. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING.
scientia non olet · About Mike's Workshop Manuals