All Doors (Except Driver) Fail To Unlock

Turn ignition off. Disconnect Remote Keyless Entry (RKE) module connector, located under pad in center of instrument panel. Using an ohmmeter, check resistance between RKE module connector terminal No. 6, door unlock driver circuit (Pink/Black wire) and ground. See Figure. If resistance is less than 1000 ohms, repair Pink/Black wire for short to ground. If resistance is 1000 ohms or more, replace RKE module. See REMOTE KEYLESS ENTRY MODULE  under REMOVAL & INSTALLATION. After repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.