Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> General Motors (Cars) >> BONNEVILLE & LE Sabre >> PASS-Key® III System Auto Learn Procedure

PASS-Key® III System Auto Learn Procedure

NOTE: PASS-Key® III system auto learn procedure must be performed if Powertrain Control Module (PCM), ignition lock cylinder, reader/exciter or ignition key are replaced.
  1. Insert a valid mechanical coded unlearned ignition key in the ignition switch. Place ignition switch in the RUN position. The SECURITY indicator light will come on for 10 minutes, the length of the auto learn timer.
  2. When auto learn timer expires and SECURITY indicator light goes off, place ignition switch in OFF position. Remove ignition key from ignition. Wait 5 seconds.
  3. Repeat steps  1 and  2 2 more times. Insert the newly learned ignition key in ignition switch.
  4. Start vehicle, vehicle has now learned key and password information. Using scan tool, clear any DTCs.
scientia non olet · About Mike's Workshop Manuals