Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2000 >> Voyager Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Fuel System Pressure Release >> 2.4L, 3.3L & 3.8L

2.4L, 3.3L & 3.8L

  1. Ensure ignition is off. Disconnect negative battery cable. Remove fuel tank cap. Remove protective cap from fuel pressure test port on fuel rail.
  2. On 2.4L, fuel pressure test port is located near front (timing belt end) of fuel rail. On 3.3L and 3.8L, fuel pressure test port is located near center of front (radiator side) fuel rail.
  3. On all models, place end of Hose (C-4799-1) into an approved fuel container. Attach remaining end of hose at fuel pressure test port on fuel rail. Use care, as fuel system is under pressure. Fuel pressure will be released from fuel system into fuel container. Remove hose, reinstall protective cap, fuel tank cap and negative battery cable.
scientia non olet · About Mike's Workshop Manuals