Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2000 >> Voyager Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Tests >> DTC P0600: Pcm Failure SPI Communications

DTC P0600: Pcm Failure SPI Communications

NOTE: Communication between processors over internal bus is monitored when ignition is on. DTC may be stored in Powertrain Control Module (PCM) when an internal bus communication failure exists between processors. Possible causes are a defective PCM.

Turn ignition on with engine off. Using scan tool, check for DTCs. If DTC P0600: PCM FAILURE SPI COMMUNICATIONS does not exist, test is complete. If DTC P0600: PCM FAILURE SPI COMMUNICATIONS exists, replace PCM. PCM is located between driver's side front fender and power distribution center, near battery. Perform TEST VER-2A  .