Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (3.2L & 3.5L V6 Engine) >> Removal & Installation >> Radiator >> Installation

Removal & Installation: Radiator: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Slide radiator down into position; seat the radiator assembly lower rubber isolators in the mounting holes provided in lower radiator support.
  2. Attach air conditioning condenser to mounting clips on radiator. Install mounting screws and tighten to 5 N.m (45 in. lbs.).
  3. Connect lower radiator hose and clamp.
  4. Install transmission cooler line bracket and attaching fastener. Connect automatic transmission hoses; torque hose clamps to 2 N.m (18 in. lbs.).
  5. Install fan module.
  6. Connect fan motor electrical connector.
  7. Connect engine oil cooler lines (if equipped). Torque lines to 18 N.m (160 in. lbs.).
  8. Install upper radiator hose. Align hose so it does not interfere with the accessory drive belt or engine. Position hose clamp so it will not interfere with the hood liner.
  9. Install upper radiator support crossmember.
  10. Connect negative cable to remote jumper terminal.
  11. Fill cooling system with coolant.
  12. Operate engine until it reaches normal operating temperature. Check cooling system and automatic transmission for correct fluid levels.
scientia non olet · About Mike's Workshop Manuals