Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Lighting Systems - Exterior) >> Headlamp Leveling Switch - Export >> Operation >> Diagnosis And Testing - Headlamp Leveling Switch - Export >> Notes

Diagnosis And Testing - Headlamp Leveling Switch - Export: Notes

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative battery cable remote terminal.
  2. Remove the headlamp leveling switch from the instrument panel (Refer to HEADLAMP SWITCH  ).
  3. Disconnect the headlamp leveling switch electrical connector.
  4. Using an Ohm meter and the table below, check the resistance between the switch connector pins 1&2.
  5. If the test results are NOT  as indicated in the HEADLAMP LEVELING SWITCH CONTINUITY table, replace the switch. If the test results ARE  as indicated HEADLAMP LEVELING SWITCH CONTINUITY table, the switch is OK at this time. (Refer to DIAGNOSIS AND TESTING  ).
scientia non olet · About Mike's Workshop Manuals