Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Air Bag Restraint Systems) >> Removal & Installation >> Passenger-Side Air Bag Module >> Removal & Installation (Deployed Module)

Removal & Installation (Deployed Module)

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Wear rubber gloves, eye protection, and long-sleeved shirt when removing deployed air bag module. See DEPLOYED AIR BAG CLEAN-UP  under DISPOSAL PROCEDURES.
  2. Roll or fold deployed air bag toward instrument panel surface and tuck into instrument panel module area. Tape ripped instrument panel pad over deployed air bag. Remove instrument panel and pad assembly. See INSTRUMENT PANEL  . Remove passenger air bag module. See Fig 2 & Fig 3 .
  3. To install, transfer all instrument panel components which are not damaged to NEW instrument panel and pad assembly. To complete installation, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS  . DO NOT connect battery at this time. Perform air bag system check to ensure system is functioning properly. See AIR BAG SYSTEM CHECK  under SYSTEM OPERATION CHECK.
Fig 1: Identifying Glove Box Close-out Assembly Screws
G99E21968Courtesy of DAIMLERCHRYSLER CORP.
Fig 2: Removing Passenger-side Air Bag Module
G99F21969Courtesy of DAIMLERCHRYSLER CORP.
Fig 3: Identifying Passenger-side Air Bag Module Reinforcement
G99I21970Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About Mike's Workshop Manuals