Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> Engine Performance >> Engine Controls - On-Vehicle Adjustments >> Throttle Position Sensor >> 4-Cylinder Throttle Position Sensor >> Breeze, Neon, Sebring Convertible & Stratus

Breeze, Neon, Sebring Convertible & Stratus

  1. Remove components for access to electrical connector at TP sensor mounted on throttle body. With electrical connector installed on TP sensor, turn ignition on with engine off. DO NOT start engine.
  2. Using Digital Volt-Ohmmeter (DVOM), check voltage at center terminal on electrical connector for TP sensor with throttle valve closed (idle position). Voltage should be within specification. See 4-CYLINDER TP SENSOR SPECIFICATIONS  table.
  3. Slowly open throttle to full throttle and note voltage reading. Voltage should smoothly increase to specification. See 4-CYLINDER TP SENSOR SPECIFICATIONS  table. Replace TP sensor if voltage is not within specification.
4-CYLINDER TP SENSOR SPECIFICATIONS

Application & Throttle Opening Volts
Breeze, Sebring Convertible & Stratus (1)
At Idle Greater Than.60 Volt
At Full Throttle Less Than 4.50 Volts
Neon (1)
At Idle .38-1.20 Volts
At Full Throttle 3.10-4.40 Volts
(1) Measure voltage at center terminal on TP sensor with ignition on. Voltage should smoothly increase when moving throttle from idle to full throttle.
scientia non olet · About Mike's Workshop Manuals