Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1998 >> Cirrus >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation - 2.5L >> Fuel System >> Fuel Pump Module >> Installation

Fuel Pump Module: Installation

  1. Ensure sealing area on shoulder of fuel tank is clean. Install NEW "O" ring on sealing area on shoulder of fuel tank.
    CAUTION: Alignment tab on bottom side of fuel pump module must engage with notch in fuel tank when installing fuel pump module. DO NOT overtighten fuel pump module lock nut.
  2. Install fuel pump module on fuel tank so alignment tab on bottom side of fuel pump module engages with notch in fuel tank. Install fuel pump module lock nut. Hold fuel pump module in place while tightening fuel pump module lock nut to specification. See TORQUE SPECIFICATIONS  . Reinstall fuel tank.
Fig 1: Locating Fuel Pump Module & EVAP Components
G98F00708Courtesy of CHRYSLER CORP.
Fig 2: Removing & Installing Typical Fuel Pump Module Lock Nut
G98G00709Courtesy of CHRYSLER CORP.
scientia non olet · About Mike's Workshop Manuals