Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1997 >> Sebring JXi, 2.4 X >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.4L >> Trouble Code Tests >> Test TC-15B - Speed Control Power Relay & Solenoid Circuits

Test TC-15B - Speed Control Power Relay & Solenoid Circuits

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION  Directory. For wiring diagram, see WIRING DIAGRAMS - 2.4L article.
  1. Using an external ohmmeter, check resistance of switched Speed Control (SC) power supply circuit Dark Blue/Red wire between brake switch connector and SC servo connector. If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open SC power supply circuit. Perform TEST VER-4A.
  2. Check brake switch adjustment. See the BRAKES article in the BRAKES section. If brake switch adjustment is okay, replace brake switch. Perform TEST VER-4A. If brake switch adjustment is not okay, adjust brake switch as necessary. Perform TEST VER-4A.
scientia non olet · About Mike's Workshop Manuals