Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1997 >> Sebring JXi, 2.4 X >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer (Except Coupe) >> Body Control Computer Tests >> Instrument Cluster Test 5E - Panel Lights Power Circuit

Instrument Cluster Test 5E - Panel Lights Power Circuit

NOTE: Perform INSTRUMENT CLUSTER TEST 5A  before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAMS  . Perform TEST VER-1A - VERIFICATION PROCEDURE  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Disconnect Heater Ventilation Air Conditioning (HVAC) control panel. Ensure connectors are clean and not damaged. Using scan tool in ohmmeter mode, measure resistance at terminal No. 9 (Orange wire) on instrument panel 10-pin connector at Body Control Module (BCM). If resistance is 5 ohms or greater, replace HVAC control panel. If resistance is less than 5 ohms, inspect ashtray light. If ashtray light is okay, repair short to ground Orange wire. If ashtray light is not okay, replace light.

scientia non olet · About Mike's Workshop Manuals