Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1996 >> Sebring LXi >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Cruise Control System - Convertible) >> Self-Diagnostics Tests >> Test TC-86B - Speed Control Switch Always High

Test TC-86B - Speed Control Switch Always High

WARNING: This page is about a different variant/trim than selected.
  1. Condition to set trouble code is not present at this time. SPEED CONTROL SWITCH ALWAYS HIGH DTC sets if an open condition is detected in speed control ON/OFF switch circuit. Possible causes are: multiplexing switch(es) (speed control switches) shorted to power, multiplexing switch(es) (speed control switches) open, ON/OFF switch open or Powertrain Control Module (PCM) failure.
  2. Observe scan tool voltmeter. Wiggle wiring harness between speed control ON/OFF switch and Powertrain Control Module (PCM). If voltage varies, repair wiring harness as necessary where wiggling caused problem to appear. Perform TEST VSS-VER. If voltage did not vary, problem is not present at this time. Perform TEST SC-VER.
scientia non olet · About Mike's Workshop Manuals